I keep getting the wrong voltage. It should be about 2.11 volts but it shows .42 volts. I am using the 8MHz internal clock on the atmega328 non-picopower model. What is going on? EDIT: Here's my code: // Configuration: // 5v------10k-------Sensor------GND // | // Analog …

Does the Arduino clock frequency affect analogRead()?

Topic		Replies	Views
Why am I getting gibberish characters? Programming	10	19800	May 5, 2021
analogRead gives 1023 regardless of voltage applied General Guidance	6	4998	May 5, 2021
long walk off a short pier!!! Interfacing	3	886	May 6, 2021
Using internal analog reference in a standalone ATmega328 chip Sensors	2	3144	May 6, 2021
analogRead problem Troubleshooting	9	7454	May 6, 2021