DS1307 error on uploading

// Date and time functions using a DS1307 RTC connected via I2C and Wire lib

#include <Wire.h>
#include “RTClib.h”

RTC_DS1307 rtc;

void setup () {
Serial.begin(57600);
#ifdef AVR
Wire.begin();
#else
Wire1.begin(); // Shield I2C pins connect to alt I2C bus on Arduino Due
#endif
rtc.begin();

if (! rtc.isrunning()) {
Serial.println(“RTC is NOT running!”);
// following line sets the RTC to the date & time this sketch was compiled
rtc.adjust(DateTime(F(DATE), F(TIME)));
// This line sets the RTC with an explicit date & time, for example to set
// January 21, 2014 at 3am you would call:
// rtc.adjust(DateTime(2014, 1, 21, 3, 0, 0));
}
}

void loop () {
DateTime now = rtc.now();

Serial.print(now.year(), DEC);
Serial.print(’/’);
Serial.print(now.month(), DEC);
Serial.print(’/’);
Serial.print(now.day(), DEC);
Serial.print(’ ‘);
Serial.print(now.hour(), DEC);
Serial.print(’:’);
Serial.print(now.minute(), DEC);
Serial.print(’:’);
Serial.print(now.second(), DEC);
Serial.println();

Serial.print(" since midnight 1/1/1970 = ");
Serial.print(now.unixtime());
Serial.print("s = ");
Serial.print(now.unixtime() / 86400L);
Serial.println(“d”);

// calculate a date which is 7 days and 30 seconds into the future
DateTime future (now.unixtime() + 7 * 86400L + 30);

Serial.print(" now + 7d + 30s: ");
Serial.print(future.year(), DEC);
Serial.print(’/’);
Serial.print(future.month(), DEC);
Serial.print(’/’);
Serial.print(future.day(), DEC);
Serial.print(’ ‘);
Serial.print(future.hour(), DEC);
Serial.print(’:’);
Serial.print(future.minute(), DEC);
Serial.print(’:’);
Serial.print(future.second(), DEC);
Serial.println();

Serial.println();
delay(3000);
}

error uploading says:

Binary sketch size: 8,450 bytes (of a 258,048 byte maximum)
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_getsync(): timeout communicating with programmer

Are you trying to upload to an Arduino Mega?