Thanks for the code, but yea, still no luck...
I can tell something is happening because the motors are getting enough power to "hold", i.e. the shaft is much harder to turn than when no power is supplied, I thought maybe I was wiring the motor wrong but again no luck with trying all the other iterations.
I just find it hard to believe that out of all four of my motors not a single one will run...
I just feel like I am doing something wrong!!!
Is there any way to tell from hooking them up to the L298 and measuring with a multimeter what kind of voltage and current they need to operate seeing as I can actually get them to move via the h-bridge?