Duinotech 328p not working

Hi all,

Recently purchase a couple of additional 328p’s from my local electronics store in Australia (jaycar) to be used in a couple of projects. They are the same brand as my current Uno (duinotech brand) and are advertised as having a boot loader on them and ready to go. However when I swap the chips out on the Uno and try to upload a new sketch I get the following errors:

avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: ser_recv(): read error: Device not configured
avrdude: ser_recv(): read error: Device not configured

I have tried uploading a new boot loader using the setup provided on the arduino.cc website but I’m worried that my only other 328p may no longer be working correctly due to an accidental short in another project. The chip I have been using to try and upload the boot loader will receive the blink sketch and operate normally it just tends to get a bit hot. It fails to upload a new boot loader to one of the new 328p’s with the error “cannot upload boot loader”

Am I missing something or has anyone had a similar issue?

Thanks

hello,

Problems happen at the beginning, do not give up!

Try to acquire new ones to try again,

Watch videos on youtube can help

Maybe this video can help something: