Eagle Cad problem using connectors

Hello all Today I'm geting crazy with eagle.I need to put a connector with 6 pins that I found on con-molex library named 22-23-2061. My problem is I can´t grab a wire on the terminals. I already tried use a wire and the button side a draw a BUS, named draw net. I already tried another terminals but the problem is the same. When I hit the wire near the terminal pin it won't grab it.Even if I zoom and place the wire above it if I move the connector aside the wire don´t go with the connector as expected.

You are trying to connect to the wrong end? Its the thin red line that's the bit you connect to - the fat ends are just drawings to symbolize the connector.