eagle PCB connection problem

Using Arduino General Electronics
#1

Hi. I'm drawing a small pcb to become a arduino due shield. I'm using Eagle to desing it.
But, even whit the grid set to finest and the zoom to maximum, many pin and net never want to connect.

I Matter if someone have an easy solution or trick or want to fix it for me.

#2

Hi. I’m drawing a small pcb to become a arduino due shield. I’m using Eagle to desing it.
But, even whit the grid set to finest and the zoom to maximum, many pin and net never want to connect.

I Matter if someone have an easy solution or trick or want to fix it for me.

DUE heater SHIELD.png
DUE heater SHIELD.png2004×1723 83.3 KB

#3

Don't change the grid from the default 0.1" in schematic mode, all the parts are designed to match it.

#4

Please don't cross post like this. Original thread here: http://forum.arduino.cc/index.php?topic=273703.0

#5

In schematic, set Grid to 0.05 inch. That's the standard.
I think CTRL-click twice on a part will move it on-grid so pins will connect properly.

#6