Error Message: Programmer is not responding

Yes, I know this is a very generic error, but I don’t know how to solve it. I am using a clone with an IR sensor code and it will not upload. I am using an Elegoo Uno R3, and it has never given this error before. I will attach the code and full error string. The error is on the top, the code is on the bottom.

ErrorMessage.txt (9.06 KB)

ErrorMessage.txt (9.06 KB)

Usually means either:

Wrong board selected in tools menu
Wrong com port selected in tools menu
Or no bootloader on the chip.

Delta_G:
Usually means either:

Wrong board selected in tools menu
Wrong com port selected in tools menu
Or no bootloader on the chip.

The board selected is correct, and the port would show that it is not the right one. It even says "Arduino/Geniuo Unoo"