Error while upload Sketch to Arduino [ATmega328]

My ATmega328 is connected via Mini UB cable to my windows 10 PC and I am using Arduino IDE.
I try to upload the simple Blink code to the Arduino, but I get the message below.

My local config is
Board "Arduino Nano"
Processor "ATmega328P (Old Bootloader)
Driver for CH340 is installed successfully.

and I am using a
Nano ATmega328 V3.1 Board with CH340 USB Chip

I already tried 3 different USB cables, but none of them worked.
Any ideas?

avrdude: Version 6.3-20190619
Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
Copyright (c) 2007-2014 Joerg Wunsch

System wide configuration file is "C:\Program Files (x86)\Arduino\hardware\tools\avr/etc/avrdude.conf"

Using Port : COM6
Using Programmer : arduino
Overriding Baud Rate : 57600
AVR Part : ATmega328P
Chip Erase delay : 9000 us
PAGEL : PD7
BS2 : PC2
RESET disposition : dedicated
RETRY pulse : SCK
serial program mode : yes
parallel program mode : yes
Timeout : 200
StabDelay : 100
CmdexeDelay : 25
SyncLoops : 32
ByteDelay : 0
PollIndex : 3
PollValue : 0x53
Memory Detail :

Block Poll Page Polled
Memory Type Mode Delay Size Indx Paged Size Size #Pages MinW MaxW ReadBack
Beim Hochladen des Sketches ist ein Fehler aufgetreten


eeprom 65 20 4 0 no 1024 4 0 3600 3600 0xff 0xff
flash 65 6 128 0 yes 32768 128 256 4500 4500 0xff 0xff
lfuse 0 0 0 0 no 1 0 0 4500 4500 0x00 0x00
hfuse 0 0 0 0 no 1 0 0 4500 4500 0x00 0x00
efuse 0 0 0 0 no 1 0 0 4500 4500 0x00 0x00
lock 0 0 0 0 no 1 0 0 4500 4500 0x00 0x00
calibration 0 0 0 0 no 1 0 0 0 0 0x00 0x00
signature 0 0 0 0 no 3 0 0 0 0 0x00 0x00

Programmer Type : Arduino
Description : Arduino

avrdude: stk500_getparm(): (a) protocol error, expect=0x14, resp=0xfc
Hardware Version: 2
Firmware Version: 0.16

avrdude: stk500_getparm(): (a) protocol error, expect=0x14, resp=0xfc

avrdude: stk500_getparm(): (a) protocol error, expect=0x14, resp=0xfc
Vtarget : 0.0 V
Varef : 198634860.8 V
Oscillator : Off
SCK period : 16390338.6 us

avrdude: stk500_getparm(): (a) protocol error, expect=0x14, resp=0xfc
avrdude: stk500_initialize(): (b) protocol error, expect=0x10, resp=0xfc
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.

avrdude done. Thank you.