I did not see the normal message sequence of upload a program to the ESP32 CAM.
After the jumper is in place, then press the button, the ESP32CAM will give a message that it is ready for upload. Then start the upload.
I do not get after pressing the reset button before uploading. There is only one button (Reset Button) on my ESP32 CAM.
Install the ESP Exception decoder and use it, look it up on the internet.
Can you please provide the link as I am completely new to it? I do not want to get misdirected.
Here is my setup :
Green wire is for Vcc (5V)
Black wire is for Ground
Yellow and Blue wires are for communication
White wire connects IO0 to Ground