Hello everyone, I’m using an ESP32-WROVER board and trying to upload a simple sketch that just prints “Hello world!” to the serial monitor. However, after uploading, the board keeps rebooting and the serial monitor shows an infinite stream of output like this: rst:0x7 (TG0WDT_SYS_RESET),boot:0x13 …

[image] karoumi: E (30) boot: Failed to verify partition table You have to play with Arduino IDE->Tools->Flash mode Also, you have to select Arduino IDE->Tools->Partition scheme->Default 4MB With SPIFFS: this will fix you bad partition table. As I said before - it is defenitely problems wit…

ESP32-WROVER stuck in reboot loop with simple Serial.println() sketch

Development Tools IDE 2.x

karoumi August 1, 2025, 7:40am 12

I did like you said here is the setup but it seems like nothing have changed!

Topic		Replies	Views
Repeating rebooting in Serial Monitor (ESP32-WROOM) Programming	4	1103	February 10, 2024
ESP32 creepy start IDE 1.x	4	2700	May 5, 2021
ESP32 reboots constantly (even with empty sketch) 3rd Party Boards	12	15498	July 17, 2021
Rebooting ESP32 in WiFi mode Software	2	889	May 7, 2021
Issues with uploading arduino code to the a ESP32 Dev board IDE 1.x	1	1152	May 5, 2021

ESP32-WROVER stuck in reboot loop with simple Serial.println() sketch

Related topics