I have wired my ESP8266 ESP8266 - Arduino Vcc -Vcc RX -RX GPIO0 -Vcc GPIO2 -Vcc CH_PD -Vcc GND -GND Then i set my baud rate to 115200 and sent an AT Command AT+RST. i got the response below ets Jan 8 2013,rst cause:2, boot mode:(3,7) load 0x40100000, len 1396, room 16 tail 4 chksum 0x89 …

ESP8266 AT Commands

Qdeathstar November 4, 2017, 6:42pm 2

I think your power supply may be suspect. What is vcc? What type of esp8266?

Topic		Replies	Views
ESP8266 Home Automation	2	691	May 6, 2021
ESP-8266-01 Networking, Protocols, and Devices	2	582	May 6, 2021
ESP8266 AT Commandes problèmes Home Automation	2	962	May 6, 2021
ESP8266 only responds AT, AT+RST and AT+GMR commands Networking, Protocols, and Devices	1	2294	May 6, 2021
ESP 8266 module, constant response INVALID Programming	32	13762	May 5, 2021