Ets Jan 8 2013,rst cause:2, boot mode:(3,6)

Using Arduino Networking, Protocols, and Devices
1

Hi everyone.
Every time I connect my ESP8266-01 to my computer using a USB to FTDI adapter, I receive the next error as soon as I reset it, and it answers to no AT commands:

ets Jan 8 2013,rst cause:2, boot mode:(3,6)

load 0x40100000, len 31320, room 16 
tail 8
chksum 0xef
load 0x00000000, len 0, room 0 
tail 0
chksum 0xef
load 0x00000000, len 0, room 8 
tail 0
chksum 0xef
csum 0xef
csum err
ets_main.c

What should I do? Thanks in advance!

2

can you upload a blank sketch to the MCU. Do not have anything connected to the device. After an upload reboot, does the checksum error go away? If not, most likely the MCU has got a booboo fatal boo boo..

3

Sorry? I could not understand.
I have not uploaded anything. I am not going to use it as a microcontroller. I am going to connect it to Arduino and use it to connect Arduino to wifi. Right now I am only connecting it to the computer, and as soon as I connect it sends that error.

4

This topic was automatically closed 120 days after the last reply. New replies are no longer allowed.