When I compile this code (which I have copied from the manual), I get the error message "Exit Status 1 - Invalid use of 'Print::Print'." Any ideas why?
Thanks.
const int greenLEDPin = 9;
const int redLEDPin = 10;
const int blueLEDPin = 11;
const int redSensorPin = A0;
const int greenSensorPin = A1;
const int blueSensorPin = A2;
int redValue = 0;
int greenValue = 0;
int blueValue = 0;
int redSensorValue = 0;
int greenSensorValue = 0;
int blueSensorValue = 0;
void setup() {
Serial.begin(9600);
pinMode(greenLEDPin, OUTPUT);
pinMode(redLEDPin, OUTPUT);
pinMode(blueLEDPin, OUTPUT);
}
void loop() {
redSensorValue = analogRead(redSensorPin);
delay(5);
greenSensorValue = analogRead(greenSensorPin);
delay(5);
blueSensorValue = analogRead(blueSensorPin);
Serial.Print ("Raw Sensor Values \t red: ");
Serial.Print (redSensorValue);
Serial.Print ("\t green: ");
Serial.Print (greenSensorValue);
Serial.Print ("\t blue: ");
Serial.Print (blueSensorValue);
redValue = redSensorValue/4;
greenValue = greenSensorValue/4;
blueValue = blueSensorValue/4;
Serial.Print ("Mapped Sensor Values \t red: ");
Serial.Print (redValue);
Serial.Print ("\t green: ");
Serial.Print (greenValue);
Serial.Print ("\t blue: ");
Serial.Print (blueValue);
analogWrite(redLEDPin, redValue);
analogWrite(greenLEDPin, greenValue);
analogWrite(blueLEDPin, blueValue);
}
