Exit status 1Exit Status 1 on Nano and most recent ide

Development Tools Uploading
20

This error might be caused by having the wrong port selected from the Tools > Port menu in Arduino IDE.

Please perform this experiment to verify that the port you have selected is your Arduino board:

  1. Disconnect the USB cable of the Arduino board from your computer.
  2. Select Tools > Port from the Arduino IDE menus.
  3. Take note of the ports, if any, listed in the menu.
  4. Close the Tools menu.
    :exclamation: The ports list is only updated when the Tools menu is re-opened, so this step is essential.
  5. Connect the Arduino board to your computer with a USB cable.
  6. Select Tools > Port from the Arduino IDE menus. - If a new port is listed in the menu, that is the port of your Arduino board.

Select that port from the menu and try uploading again.

If the upload still fails, or if no new port appeared after you plugged the Arduino board into your computer, add a reply here to let us know and we'll investigate the problem further.