Well I actually have a couple of questions :
Tried to figure out the way to use your links but it's a bit blurry to me, even if i read your topic about the DC motor controlled over Wifi.
First i get you needed to go thru the Pymata client anyway in order to get the information from Firmata,then you've got a link between Pymata and an other couple of softwares patchs (s2a_fm and Snap!).
To have it to work thru wifi you put the python stuff (including s2a_fm) in the linino of the Yun, then send it to Snap! thru wifi.
This is fine to me.
But how can i do it with max/msp ? I mean, i guess i need something else to get the information from Pymata up to maxuino, isn't it ? (Tried to see some incoming information from a simple potentiometer within maxuino max4live device, but nothing shows up)
Also, so far i guess there must be a mistake within my installation, i can't have the blinking exemple to work with Snap! (as in your tutorials).
To be clearer i should say, I installed python 2.7, then py.serial, then pymata
I'm wired thru usb (micro-usb,maybe it's about the standard one in your exemple, I imagined not because linino isn't used i your exemple)
Now i try to launch the s2a_fm soft in the console but it answers me "COuld not instantiate Pymata. Is your Arduino plugged in ?" which it is obviously.
I actually imagine i could try to get the information into snap! then transmit them with OSC to a max patch...
Thank you