As Shown in Prototype this Show , on Episode 13 they have created a modern life saving guard , using canon based , and UAV Airplane the problem is they have the all , Electronic Used as , Parallax Professional Development boad , Basic stamp and Parallax GPS receiver ... code is available but the thing is can i migrate , Basic Stamp Code into Arduino or i have develop it ? .. if i have to does it help somewhere ? ..
Where are the sources? Its hard to tell anything without looking at the code.
Sir you can download the source code and other development notes from here
please have a look ! help me out if it could be done with arduino , as much i think it can .. ! but the problem is code migration
Do you want me to move this to "Gigs and collaborations"?
AWOL: Do you want me to move this to "Gigs and collaborations"?
He hasn't offered money yet. :)
mushahid980: Sir you can download the source code and other development notes from here http://www.grandideastudio.com/portfolio/pt-flying-lifeguard/ please have a look ! help me out if it could be done with arduino , as much i think it can .. ! but the problem is code migration
Did you want to convert both the Canon Targeting System (http://www.grandideastudio.com/wp-content/uploads/21lsd_cannon.bs2) AND the Wristband GPS Transmitter (http://www.grandideastudio.com/wp-content/uploads/21lsd_wristband.bs2)?
He hasn't offered money yet.
You don't necessarily have to pay for a collaboration
Relax Guy's :) .. well you 2 look's both genius my question is simple once again i am going to make the Canon not looking for UAV , the problem is can i control the Physical variable Using Arduino... instead of using Parallax Development board .. ? , as i have to drive two servo , pressure sensor and solenoid valve as output , for the input there are weather info (speed , direction) , and RF info( About G.P.S Cordinates and distance) ..
I would say you can do it better on the Arduino without having BASIC getting in the way.
Thanks alot :) AWOL , .. i would say it would help me out !