fuses

Hello,
I'm would like to know if the fuses are the same if I want to flash an atmega328 without bootloader.?
low_fuses=0xFF
high_fuses=0xDA
extended_fuses=0x05
???
And the lockbit I dont have to set, right?
Thanky You very much short notice!
Sibylle

ok, I have tried now to upad the bootloader - but still I'm getting just error messages; is there probably a problem between avrdude and old stk500 and new atmega328???

avrdude: successfully opened stk500v1 device -- please use -c stk500v1
avrdude: Expected signature for ATMEGA328P is 1E 95 0F
Double check chip, or use -F to override this check.
and Im looking for where I could make this changes proposed by avrdude....making -c stk500v1 instead of -c stk500...???
Thanx for any help, suggestions etc. and hope not to annoy you all.
sibylle