getting a sanguino to work

hope you will let me ask a question about a sanguino

am trying to make a sanguino to work and am not having much luck.

i d/l the sanguino files from the sanguino site and put the files in the hardware folder in the arduino folder

the board is set to sanguino comport is set to 4 that is where the usb cable is connected.

i get the red and blinking green lites on the board when starting.

i tried to run the blink example but when it tries to load it says

binary sketch size: 1002 bytes (of a 63488 bytes maximum) avrdude: stk500_getsync(): not in sync: resp=)x)) avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

what am i doing wrong or what else should i have done.

is there a list for discussion of the sanguino board.

is there a schematic of the serial cable.

and somewhere i saw a list of the correspondence between arduino and sanguino pins

i really don't want to bug you but


dave alexander k7da


Quick question… Have you installed a bootloader on the Sanguino? The one time I saw an error like that I had somehow managed to munge the bootloader on an ATmega328. Reburn the bootloader and all was well.

I don’t know what you have for a programming device but installing a bootloader via the IDE and my USBasp programmer was painless.