GLCD Character display problems

Forum 2005-2010 (read only) Hardware Interfacing
1

Hello all,
I am using a Duemilanove and 128 *64 GLCD but I am unable to start my GLCD - bought from sparkfun. I have the backlight on after the connections but I am not getting any characters printed on it at all. This is my GLCD: Graphic LCD 128x64 STN LED Backlight - LCD-00710 - SparkFun Electronics
I have made connections as shown for Panel A here: Arduino Playground - GLCDks0108
Despite the connections and hour-long efforts, nothing at all. I have tried several libraries like KS0108 and GLCD library. But so far, i m unsuccessful.

Please help me out here folks.

2

Cross-posting is not the solution.

3

maybe you could just have posted the solution rather than a word of advice.

4

maybe you could just have posted the solution rather than a word of advice.

Where? Here? Or your other thread?

5

how many from those 7854 posts are like those stated above?

6

Probably the same signal to noise ratio as you.

7

pity being a god member. :stuck_out_tongue:

8

pity being a god member

Try posting a character mode LCD question and I'll try to remember not to answer it.

Don

9

:slight_smile: again pity.