GPS NEO6M not working properly

Hello,

I have my gps working with arduino nano. I have the same sample with provided library code(tinygps). For the first time when I plug in gps it is working properly and I am getting correct data. However, When I plug out and plug it again I do not get any data. I need to re-upload the code to ardunio then it start to work again. I need to solve this as soon as possible.

Thank you in advance

Stronghold_:
Hello,

I have my gps working with arduino nano. I have the same sample with provided library code(tinygps). For the first time when I plug in gps it is working properly and I am getting correct data. However, When I plug out and plug it again I do not get any data. I need to re-upload the code to ardunio then it start to work again.

A bit more information might help the forum, what exactly are you doing here;

"When I plug out and plug it again I do not get any data"

Which device are you referring to ?

I need to solve this as soon as possible.

The best way to get the fastest advice, from the voulunteers on these forums, is to post as much information as possible in your first post describing in detail what is actually happening.

Does it behave the same if you use another sketch, such as the "Blink" from the IDE's examples.

TX on the module goes to RX on the Arduino. RX on the module goes to TX on the Arduino. there is a good chance you swapped those around.