I followed the plans you layer out , and I was getting readings yay!!!!
but then all of a sudden it just doesn't work 
nothing.
I was getting readings that were totally responding as I would expect.
I was going to see if I could hook up another board, but before I could it halted any readings and when I press reset on the Arduino it reads:
MPU-6050
InvenSense MPU-6050
June 2012
and nothing else
If I pull the:
A4 and A5 from The SDA and SCL
it scrolls, but unresponsive:
MPU-6050
Read accel, temp and gyro, error = 2
accel x,y,z: -5374, 2, 305
temperature: 37.212 degrees Celsius
gyro x,y,z : 2050, -13039, -29695,
MPU-6050
Read accel, temp and gyro, error = 2
accel x,y,z: 747, 512, 12545
temperature: 24.459 degrees Celsius
gyro x,y,z : 520, 4557, 396,
MPU-6050
Read accel, temp and gyro, error = 2
accel x,y,z: -5374, 2, 305
temperature: 37.212 degrees Celsius
gyro x,y,z : 2050, -13039, -29695,
MPU-6050
Read accel, temp and gyro, error = 2
accel x,y,z: 747, 512, 12545
temperature: 24.459 degrees Celsius
gyro x,y,z : 520, 4557, 396,
dang did I fry my chip somehow?