Hi everyone...
I'm trying to use L298N - H-bridge to control DC motors but after the connection, it seems like it has a problem, cause the motors never rotate, i tried to use a resistor in place of the motor and then placed a voltmeter across the resistor to measure the average DC around the resistor, i measured around 0.05v around it even though i supplied the driver by 12 volt !!
can anyone help me on this please ?
No code, no schematic, no values - no help.
sorry my friend... suppose that there is no problem with the code and the connection, as i copied everything from a working structure
OK, I'll do that.
Good luck.
1 Like
This topic was automatically closed 120 days after the last reply. New replies are no longer allowed.