Hall Effect Sensor Simulator

Projects General Guidance
2

Hi,
Welcome to the forum.

Please read the first post in any forum entitled how to use this forum.
http://forum.arduino.cc/index.php/topic,148850.0.html

sunybeet1987:
I need to set up a hall effect sensor with set 3 bit pattern

101
100
011
010
001
110

I would to vary the rate of 1Hz to 50 Hz to simulate the motor rotation.

000 & 111 are error conditions that I might need to insert.

I would drive the printed circuit board under test with an Open Collector or Isolator.

How easy is the LCD Touch screen to program an interface?

Thanks,
Greg

So you want an Arduino to output through 3 digital outputs the above bytes.
You will be simulating 3 Hall Effect devices?
Can you tell us your electronics, programming, Arduino, hardware experience?
To connect your simulator to the device under test , opto-couplers would probably be the best.
Tom... :slight_smile: