Did you sucessfully upload sketch via bluetooth?
I have connected pin 4 RTS of HC05 via capasitor to pin
reset of arduino, its pin 1 of atmega. And upload of sketch from arduino IDE
not workng. Why?
Arduino IDE puls down RTS to enable reset of atmega, and start boot loader.
Did IDE detects HC05 as standard serial port. I paired hc05 and see in details of driver com8
can run puTTY to talk over com8 to atmega, but IDE do not see com8, but com9.
do you thing this is problem?
Do not talk about pushing reset button before uploading or software methode of
pulling down Reset pin, i do not want tak abut it.