Folks, I have connected an HC-12 transceiver to an Arduino Nano using pins 10 and 11 for the TX and TX connections. I also connect the set pin on the HC-12 to ground to put it in command mode. I uploaded the following code and brought up the serial monitor. The serial monitor indicates "Enter T com…

HC-12 commands not communicating

Topic		Replies	Views
HC-12 AT commands no longer seem to work Networking, Protocols, and Devices	10	3337	November 29, 2022
RF HC-12, run AT commands by arduino Programming	5	4851	May 5, 2021
HC-12 433MHz can't configure Networking, Protocols, and Devices	4	2080	May 6, 2021
HC-12 & Nano - hardware or software problem? Networking, Protocols, and Devices	6	2264	May 6, 2021
HC-12 problems with communication to pc Programming	4	699	May 6, 2021