hello, my name is sergio, I'm from Argentina, I built a homemade CNC with Arduino Uno + shield cnc, drv drivers, loaded with firmware grbl 0.8c, which use to communicate the unioversal gcode sender, and images use software aspire 8.5 but so far I could not find a correct for this electronic postprocessor, could help me build one or find the right
siroloco:
images use software aspire 8.5 but so far I could not find a correct for this electronic postprocessor,
I suspect that is a PC program rather than an Arduino program so this is not the place to get advice. Maybe try some of the CNC forums.
...R
Hola Sergio, grbl está en proceso de desarrollo (como cualquier software con licencia GPL que se precie ), por lo que existen algunas instrucciones en código G que tal vez aun no se han implementado. Yo te recomendaría probar cargando la última versión de grbl 0.9J en tu Arduino.
También podrías intentar usar el posprocesador Shapeoko en ASPIRE, ya que esta CNC está basada en Arduino (según entiendo).
Espero que te vaya bien, y nos cuentas cualquier avance... o no, ya que de los errores también aprendemos.
Saludos
William
@wScorpion, this is the English language section of the Forum so at least please provide an English version of your Reply #2 so that other people can benefit from your advice.
It's a lot less confusing to stick to English in the English section.
...R