Help with Arduino Uno and ENC28j60 to Raspberry Pi Connection

Projects Networking, Protocols, and Devices
7

Yes I have. Using the code below I recieve "⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮⸮" in the serial moniter

Sure, because that code is setting the baud rate to 9600. You have to select the baud rate in the serial monitor that is selected in the sketch.

IPAddress ip(192,168,1,177);

and

This page isn't working
192.168.0.10 didn't send any data.
ERR_EMPTY_RESPONSE

Do you see the problem? (Hint: it's about IP addresses)