Shouldnt be too hard, only problem is that the loadcells can out out up to 8.8v... too high for the Analog pins i think. How can I turn the 8.8v into 5v? Resistor? I would prefer not to have to completely redesign the load cell setup to run on 5v :slight_smile: Ryan

Help with Measuring Load Cell Voltage

wwbrown November 3, 2012, 3:33am 3

Listen to Lefty he is making good sense, pat manufactures and numbers and a schematic would help,

Topic		Replies	Views
Load Cell Data Acquisiton with Arduino Science and Measurement	5	3666	May 6, 2021
Load cell interface Interfacing	7	2569	May 6, 2021
Need to amplify signal from a sensor General Electronics	3	1341	May 6, 2021
Arduino Uno r3 + 1kN load cell = how to amplify problem Sensors	8	5609	May 6, 2021
Leggere una Cella di carico Generale	8	7457	May 7, 2021