Hello all,
Newbie here.
I recently purchased a digital thermostatic mixer for my upcoming bathroom renovations.
The thermostatic mixer has a small console that controls temp adjustment to the mixer.
the mixer is just like a faucet mixer but controlled with a stepper motor.
The console has temperature control and temp display. The temp control buttons are also touch sensitive.
My plan is to have a Faucet and a N.O. latching Piezoelectric switch controlling a slow close water valve to allow or not allow water flow.
With another 2 N.O momentary Piezo switches to control temp adjustment (I like the aesthetic look of buttons and not the console)
I basically want the temp and water flow controlled from 3 piezo switches and the console hidden or not installed, if able.
I did a tear down of the mixer and found 4 cables running to the console, 5vdc (red), GRND (Black), CLK (yellow) and DAT (blue). Pictured*
I recently learnt that the mixer is using a Clocked Serial Bus for communication, I'm hoping its i2c.
I want to try and decode the mixer's console Clock speed and the Data transfered. By doing this i think i can send a signal (raise/lower temp) to the mixer from a nodemcu esp8266, activated by a hardware pin from a NO Piezo switch.
Any help is greatly appreciated, also my arduino is pretty limited so please excuse me if i say something stupid.
Thank you
