Hi,
whenever I'm trying to setup an original HM-10 bluetooth module for scanning bluetooth devices it just locks up mid-air:
AT
AT+RENEW
AT+ROLE1
AT+IMME1
And after that it responds with an OK, but from then on whatever I'm sending doesn't work (like AT+RESET etc.) unless I start sending AT over and over again when it then becomes somewhat active again and I can send an AT+RENEW to reset it.
I'm never getting anywhere else as it locks up after AT+IMME1 (using any terminal program, I've tried a few).
Am I doing anything wrong or is it just broken and I have to replace it? Using the latest v542 firmware already on the chip.
Can someone reproduce it?
Other commands like AT+IBEA1 and AT+NAME? work without any problems until I sent AT+IMME1