Hello, I am an eee student and I am trying to make a bms package based on LTC680x ICs. When I searched on the forum, I see some people did it before. But I can't find any proteus libraries for these ICs and I can't find any design schematics of them. What should I do?
Did you check the datasheet for the device ?
There is a design schematic in there.
Mr. srnet I checked the datasheets but from what I see, they only have pin configurations and block diagrams. I want to be able to simulate my design. If you're sure that it is possible to do this by reading datasheets. Could you teach me the steps I should be following to do it?
akaanb:
I want to be able to simulate my design.
You asked for a design schematic so I pointed out where there was one.
A question on how to simulate the device is probably better asked in the Proteus support forum.