How to send data over xbees in api mode using arduino uno

Hi all,

I am a newbie at wireless communications and arduino. A part of a project I am working on now is to send an image from a camera module connected to an arduino uno wirelessly to my computer using xbee. I am currently struggling to figure out how to use api mode to transfer data from the xbee on my arduino to the xbee connected to my computer. It will be great if I could receive some advice and help on this issue. I am using xbee series 1.

Also, I am not sure how to interpret the data the xbee receives and display it on the computer. Any help is greatly appreciated. Thanks!

Don't see where I can find the old post from the page... Will be great if you can link me the actual post

I am currently struggling to figure out how to use api mode to transfer data from the xbee on my arduino to the xbee connected to my computer.

Why do you need to use API mode?

Are you using Andrew Rapp's XBee library? It handles all the packing/unpacking of data into/from API packets.

If not, why not?