The following code is for testing the lifetime of an actuator. When the actuator is contracted, it outputs a value of 0.4V based on hall sensors that I can tap into. When it's going up or down, it outputs a value of 2.4V When it's extended, it outputs a value of 1.4V I use two relays to control …

How to stop/do something if analog value has not changed in a certain amount of time

thahir2020 October 7, 2021, 6:18pm 4

I'm a total newbie. Would you please explain this?

Topic		Replies	Views
counting state change in analog input Programming	29	10005	May 5, 2021
counter analog Syntax & Programs	4	1250	May 6, 2021
time problem (analogRead) Programming	4	974	May 5, 2021
compare sensor data range over time to shut off Programming	19	7758	May 5, 2021
sensor data question Programming	15	6366	May 5, 2021