so I've recent wanted to set up a smart hydroponics system, and have proceeded to purchase this card. I've downloaded Arduino IDE an was all set to go until i tried running a test sketch of (blink) . where I have been running in to the same issue.
I've run through all trouble shooting option I've personally found as well as all chatgpt options. I've purchase the same board again, and the problem has persisted.
I've also run it on a linux system as well as a windows system and i feel like I'm bouncing my head against a wall at this point.
the link is new so I'm going to follow that... but any further insight would be appreciated.