I tried to program an ATmega328p on breadboard, but it didn't work

Hello everyone, today I tried to program an ATmega328p-pu (with the bootloader, because I took it from the original board) on a breadboard, following this:

I tried to do it with the minimal configuration, because I don't have a 10k resistor.

I've downloaded the BREADBOARD hardware library and selected the "Arduino as ISP" programmer
From the tools menu the board was: Atmega328p on a breadboard (8mhz internal clock)

I think it is all right.
The connection (with jumpers) is perfect looking for the original draw.

PS: error:

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding

The error obviously continue for all the 10 attempts.

THANK YOU!