Hello all I'm testing a stand alone Arduino Edge Control (without any MKR shield installed) and can't find a way to activate the I2C bus pins that are available on both MKR1 and MKR2 slots. In the Edge Control program, the following power lines are enabled // Enable power lines Power.enable3V3()…

Update: I'm now able to get readings with standalone EDGE CONTROL from the GY-521 connected to MKR1 slot pins SDA, SCL, GND, VIN. Don't understand why it failed in the previous test (see previous post); could be some issue with the GY-521... Solution to original problem: Originally, when I couldn…

I2C on Arduino Edge Control

Projects Networking, Protocols, and Devices

migreis September 10, 2021, 8:25pm 9

Thanks for your help and info!!

Topic		Replies	Views
About Sharing of I2C interface Sensors	14	4700	May 6, 2021
I2C on which device??? Interfacing	7	1663	May 6, 2021
zwei Arduinos über I2C und Stop des Masters Deutsch	2	967	May 6, 2021
Chiarimenti sull'I2C Generale	7	1626	May 7, 2021
I2C device not recognized-brushless gimbal controller and gy-521 Networking, Protocols, and Devices	25	13024	May 6, 2021

I2C on Arduino Edge Control

Related topics