Hi there I have a Arduino Nano project with 2 I2C devices. First, a 16x2 display and a compass. The I2C wires from the compass are soldered to the display, from where the wires go to the Nano, via a pull ups on both lines. Unfortunately I only had 10K resistors for the pull ups. I know, the values…

I2C problems with 2 devices

Topic		Replies	Views
i2c crash with 10k [ch937] pullups.. ok with 2.2K [ch937]. ??? Interfacing	18	9649	May 6, 2021
I2C - working w/ Duemilanove, not w/ Nano Networking, Protocols, and Devices	15	6016	May 6, 2021
Conectar dos dispositivos por I2C Hardware	8	4986	May 7, 2021
I2C Display Troubleshooting	18	6560	May 6, 2021
Increasing I2C pull-ups via additional resistor? General Electronics	7	2340	May 6, 2021