Thanks for the add...My 1st post here I am using an Ardunio Uno and FastLED library for my 1st project. I have the LED strips (WS2812B) working like I like but I then wanted to use my UNO with two inputs to drive two outputs. I cut'n pasted my working code into the IF/ELSE statement and it doesn'…

"If" statement and LEDs not working correctly

kerrys914 November 2, 2017, 5:35pm 3

I am not using one.

I am adding or removing 5v at pin #8

My thought was, if 5v is at pin#8 to the true code

Topic		Replies	Views
really stuck on IF statments Programming	4	836	May 5, 2021
NEWBE! Semplice circuito con LED e gestione INPUT / OUTPUT Generale	7	1133	May 7, 2021
IF statement runs even though condition is not satisfied Programming	12	1198	May 5, 2021
Problem with "if" and "else" commands Programming	10	2771	May 5, 2021
If - Else Programming	7	762	May 5, 2021