Hy I currently use an Arduino to control a device over an IR LED. Is it possible to use two wires directly from the Arduino output to the IR of the device and use the same code I used before to control it via the IR LED? Andy

Instead of IR transmitter / receiver, wire directly?

system April 17, 2014, 7:25am 4

hmm thx for the reply's.. Sounds a bit too complicated... But I will give it a try

Andy

Topic		Replies	Views
IR Rx and or Opto Isolator General Electronics	9	3017	May 6, 2021
Replacing IR link with wire General Guidance	7	1821	May 5, 2021
Controlling IR LED strip with Arduino. General Electronics	2	1197	May 6, 2021
Sending data over IR ? Programming	5	601	May 5, 2021
IR remote capable device by wire with an Arduino Interfacing	2	10837	May 6, 2021