the silver(or probably steel) bent contacts under the spring switch on both sides(forward rev l and r) are gonna b attached to wires that i will solder onto them and these leads will be fixed to jumpers (m/f) to act as inputs to the arduino. . . if i am right these inputs show an analog voltage signal upon interaction with the contacts, so maybe i'll have to put them in the analog input ports of the ard. Again, i aint sure bout it.
if analog, how am i supposed to write my program such that when a signal is present, i can vary digital output pins of the arduino to high or low, so that my motor runs via L293D ic.
in short, i wanna read analog, and vary digital output based on what i read.
thnx!!