Hi Brains trust. I am relatively new to Arduino. This is my second project. I am trying to setup a relay timer where the trigger switch can be used to both initiate the timer and activate the relay, as well as reset the relay and turn it off if required. Currently I have the duration set to 10sec,…

You have the triggerPin set as INPUT. That suggests you have the switch wired with one side connected to the trigger pin and the other to 5V. If the is the case, when the switch is pressed, the pin will go high but when you release the switch it will be floating unless you have a resistor attached …

Interrupt condition not working

Projects Programming

PickyBiker September 21, 2021, 12:58am 9

Glad it's working for you and thanks for the feedback.

Topic		Replies	Views
Having problems with AttachInterrupt and Relay General Electronics	9	1499	May 6, 2021
Help Can't get Inturrupt to work.. Programming	4	1212	May 5, 2021
Using interrupts Due	10	4339	May 6, 2021
Could some with Interrupt coding knowledge look over my project help me?? Programming	6	1103	May 5, 2021
Can I choose where to restart after external interrupt? Programming	2	1200	May 5, 2021

Interrupt condition not working

Related topics