IR Servo project

Other Hardware General Electronics
1

The purpose of my project is to control motor from ir remote.
For this I modified servo (to 360 deg) and use IR receiver.

Everything I connected to andruino and it works, but when I move atmega to pcb I'm expecting strange behavior: servo works and changes direction according to my commends from ir remote and after couple changes it stops. When i reset device (cut of power and plug in again) it starts and work properly till it stops again.
Im fighting with it for couple days and I don’t have much experience in electronics (in fact it is my first project)
Below it is schema of my connections.

Maybe somebody with experience could give me some tip?

2

The schematic looks fine. How about posting the code and possibly some clear pictures of the PCB/soldering?

3

Maybe a 10 Kohm resistor from reset to Vcc, and a 100 nF capacitor from Vcc to Gnd

4

Yes, if they are not already done, they are a must. I guess I should never assume.

5

Guys,
You are great.

I added this two elements and everythink works like a charm.

Here I added schema and images for if somebody will be interested in this topic in future.

Thanks again.