The purpose of my project is to control motor from ir remote. For this I modified servo (to 360 deg) and use IR receiver. Everything I connected to andruino and it works, but when I move atmega to pcb I'm expecting strange behavior: servo works and changes direction according to my commends from i…

IR Servo project

Erni November 17, 2012, 9:39pm 3

Maybe a 10 Kohm resistor from reset to Vcc, and a 100 nF capacitor from Vcc to Gnd

Topic		Replies	Views
[issue] Loosing connectivity to my servo Motors, Mechanics, Power and CNC	6	1348	May 6, 2021
IR receiving AND servo control... Troubleshooting	8	1858	May 6, 2021
Problem with IR remote and UNO General Guidance	5	1206	May 5, 2021
Controlling Servo with IR Controller General Guidance	5	995	May 5, 2021
My servo is messing with my IR signal Programming	5	883	May 5, 2021