UPDATE: 7/20/2017 Well, I built the Garage door lock I was trying to make with the Arduino. I did notice I had some errors with the wiring diagram originally attached. I had the 5v- ground going to the ZFM-80 and the Limit switch, and not the 5v+. Also, I needed a pull-down 10k resistor from pin 2 …

Is my wiring diagram correct to have nano run garage door lock via zwave switch

Blue2swing July 21, 2017, 1:58pm 5

Here's the Video of the Lock working. Please let me know if I'm doing something wrong. Thanks :).

Topic		Replies	Views
I partially fried my arduino, help me not do it again General Guidance	22	8034	May 5, 2021
5v relay on a nano. Why isn't it switching General Electronics	22	4816	May 6, 2021
Wire up for relays using ground as switch trigger General Guidance	28	6566	May 5, 2021
Relay Controlled Door with Limit switches. Programming	13	4392	May 5, 2021
Nano funktioniert nicht mit externer Versorgung Deutsch	23	5308	May 6, 2021