I have a Nano board, which is fed from an external power source. It is getting 24V supplied to it. It is supposed to be 10V powered via an LM317, but on power up the trimpot controlling the LM317 is sometimes set to full 24V!!. I need to measure the supply voltage, and blink the on-board LED if it i…

[image] wiresplus: I don't seem to have found it anywhere, and I suspect it's not supported. 1. Without giving any power, make the following setup as per Fig-1. [nanoPicLM317] Figure-1: 2. Disconnect A5, Vin, and GND wires from NANO. 3. Connect DVM across 1uF capacitor of power supply…

Is there a way to monitor the +VIN voltage in Nano?

Development Tools IDE 1.x

Whandall August 25, 2021, 10:55am 17

I hope these are not controlling/measuring something important.

Topic		Replies	Views
Vin Pin Arduino Nano Deutsch	7	37887	May 6, 2021
Chiarimento VIN arduino Nano 3.0 Hardware	9	12805	May 7, 2021
AnalogRead Voltage different when using VIN? (Nano) Sensors	18	11284	May 6, 2021
VIN limits - are they even accurate? IDE 1.x	6	1798	May 5, 2021
I partially fried my arduino, help me not do it again General Guidance	22	8044	May 5, 2021

Is there a way to monitor the +VIN voltage in Nano?

Related topics