okay i went through the 3 scripts to find the most pertinant data
the following is from the graphics test file from adafruit
Teensy3.x and Arduino's
You are using 4 wire SPI here, so:
MOSI: 11//Teensy3.x/Arduino UNO (for MEGA/DUE refere to arduino site)
MISO: 12//Teensy3.x/Arduino UNO (for MEGA/DUE refere to arduino site)
SCK: 13//Teensy3.x/Arduino UNO (for MEGA/DUE refere to arduino site)
the rest of pin below:
*/
#define __CS 10
#define __DC 9
/*
Teensy 3.x can use: 2,6,9,10,15,20,21,22,23
Arduino's 8 bit: any
DUE: check arduino site
If you do not use reset, tie it to +3V3
*/
this code was created by others.
from the sd card code file
/*
This display:
This particular display has a design error! The controller has 3 pins to configure to constrain
the memory and resolution to a fixed dimension (in that case 128x128) but they leaved those pins
configured for 128x160 so there was several pixel memory addressing problems.
I solved by setup several parameters that dinamically fix the resolution as needed so below
the parameters for this diplay. If you have a strain or a correct display (can happen with chinese)
you can copy those parameters and create setup for different displays.
*/
what do you think?