SamuelCB:
Hi Mark,Well I wasn't 100% sure if i'm honest with you which is why I was asking my original question, however I did assume that you could just plug the xbee into a breadboard and then use jumper to connect it to the Arduino?
As for the wireless sd shield do you mean this? http://www.coolcomponents.co.uk/catalog/wireless-shield-p-861.html
If so then I assume this does not replace the xbee bu that the xbee fits onto this? Would this be instead of the xbee explorer regulated? And do I need to by a SD card for this then?
Thanks again!
Yes that's the shield. If you look in hardware on the main site you'll find all the instructions. Take a very good look a the use of the micro switch which allows programing of the uno or communication with the Xbee.
The SD slot is just an extra and you can just ignore it.
Yes you just plug the shield into the uno and the xbee into the shield.
Mark