Issue with uploading anything through parallel programmer

Hi, I am trying to upload the arduino bootloader to an arduino UNO with a blank 328p over a parallel port programmer I made however every time I try to upload the bootloader I get this error: Parallel programmer error - Pastebin.com

Note that I do have the right board selected in the arduino IDE.

some info about the system i am trying to upload from:

  • running windows 10 home 64 bit
  • using a PCIE parallel port card with this address: paralleladdress
    (note that the address of both the card and the port are the same in windows)
  • installed giveio 64 bit

does anybody know what could be going on and how to get my parallel programmer to work?

This topic was automatically closed 120 days after the last reply. New replies are no longer allowed.