Issues after installing TH3DUF_R2

Other Hardware Motors, Mechanics, Power and CNC
1

Hi,

I recently replaced my Ender-5 board with a Creality Silent Board and downloaded the latest Flash TH3DUF_R2 and ran it. I followed the instructions and ran the file and everything wrote just fine without an error. When I tried to reset my EEPROM afterwards, the verbage in the menu was different but I thought nothing of it and reset it as instructed in the instructions. When I tried, it beeped twice and did nothing, but after I restarted the printer it still said TH3D on the LCD even though I uncommented the line that was supposed to change that to Ender-5. Thats not a big deal but now when I try to home my printer the bed drops and all the Axises seem to grind and eventually go to a Printer Halted state. I tried to re-run the the flash and it it basically reports back storage info and thats it like it is sitting in there successfully "Sketch uses 108712 bytes (83%) of program storage space. Maximum is 130048 bytes. Global variables use 4535 bytes... "

I am kind of lost at this point. Hopefully someone can please assist as my printer is totally out of commission at this point.

2

This Forum is not the place to get answers to your sort of question. You may have more luck on the RepRap Forum that specialises in 3D printing. Or maybe there is a Forum for the specific printer or software you are using?

This Arduino Forum is for helping people write their own programs. By comparison the code for a 3D printer is very large and very complex.

...R