It doesn't upload anything

Using Arduino Avrdude, stk500, Bootloader issues
#1

Arduino: 1.8.5 (Windows 7), Board: "Arduino/Genuine Uno"

Sketch uses 928 bytes (2%) of program storage space. Maximum is 32256 bytes.
Global variables use 9 bytes (0%) of dynamic memory, leaving 2039 bytes for local variables. Maximum is 2048 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x18
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x18
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x18
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x18
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x18
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x18
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x18
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x18
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x18
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x18
Problem uploading to board. See Arduino Help Center for suggestions.

This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.

#2

Hi tbh I have no idea what all that code means.
What I can suggest is that you unplug the USB cable, restart the Arduino Program, and try again.

#3

Please do this:

  • File > Preferences > Show verbose output during: > compilation (uncheck) > upload (check) > OK
  • Sketch > Upload
  • After the upload fails you’ll see a button on the right side of the orange bar “Copy error messages”. Click that button.
  • Paste the error messages in a reply here USING CODE TAGS (</> button on the forum toolbar).
#4

Do you have anything connected to pins 1, 0 or reset? Those pins are used for upload, and anything connected to them will interfere

#5

Did you select the correct com port?

Check in device manager what happens when you connect or disconnect the board.

When connected, an original Arduino should identify itself as such and with a com port in the ports section. A clone might simply identify itself as a serial adapter with a com port.

It's that com port that you need to select in the IDE.

#6